Page 68 - LIT-18626-12-56

Maintenance

(2) Remove the four screws, and then re- (8) While holding the steering pole, move
move the handlebar cover. the lock pin to the stowed position, and
then lower the steering pole.
EJU3128A
Adjusting the jet thrust nozzle angle
The angle of the jet thrust nozzle can be ad-
justed to two settings to suit operator prefer-
ence.
1 To adjust the jet thrust nozzle angle:
(1) Remove the two bolts, and then remove
the steering pole cover.

1 Handlebar cover
(3) Turn the handlebars so that the left han-
dlebar grip is facing down.
(4) Loosen the locknut.
(5) Tighten or loosen the adjusting nut until
the desired amount of friction is ob-
tained.

1 Steering pole cover
(2) Pull back the outer sleeve of the steering
cable joint, and then disconnect the joint
from the steering cable pivot bolt.

1 Adjusting nut
2 Locknut
(6) While holding the adjusting nut with a
wrench, tighten the locknut to the speci-
fied torque.
1 Steering cable joint
Tightening torque:
Locknut:
28 N·m (2.8 kgf·m, 21 lb·ft)
(7) Securely install the handlebar cover and
four screws in their original positions.

61