Page 66 - LIT-18626-12-56

Care and storage

z Steering cable ball joint (jet thrust nozzle (4) Run the engine at a fast idle.
end) and steering cable inner wire (jet (5) Quickly spray as much rust inhibitor as
thrust nozzle end) possible through the hole in the silencer
cover. Use Yamalube Stor-Rite Engine
Fogging Oil or an equivalent. Keep
spraying until the engine stalls (or a max-
imum of 15 seconds). WARNING! Do
not pour or spray gasoline, or any sub-
stance other than a rust inhibitor
through the hole in the silencer cover.
Do not spray flammable rust inhibitor
products on engine surfaces while the
engine is hot. Otherwise, a fire or ex-
EJU40935 plosion could occur. [EWJ00302]
Rustproofing
(6) Securely install the silencer cap by tight-
ECJ01361
NOTICE ening it until it stops. NOTICE: Be sure
to install the silencer cap securely af-
Do not run the engine for more than 15
ter fogging the engine, otherwise wa-
seconds on land without supplying water,
ter could enter the engine and cause
otherwise the engine could overheat.
damage. [ECJ00153]
Spray metallic parts of the hull and engine (7) Securely install the hood in its original
with a rust inhibitor such as Yamalube Sili- position.
cone Protectant & Lubricant.
To rustproof the internal engine components:
(1) Remove the hood. (See page 26 for hood
removal and installation procedures.)
(2) Loosen the silencer cap and remove it.

1 Silencer cap
(3) Make sure that the area around the wa-
tercraft is clear, and then start the engine
in a well-ventilated area.

59