Page 51 - LIT-18626-15-26

UF5R10E0.book Page 42 Friday, September 27, 2024 5:44 PM

Watercraft operation

RPM x1000

MPH
Cruise Assist +5
14.3v
1 2
1 Cruise assist indicator
To unlock the drive control mode:
2 Cruise assist level
(1) Select the drive control mode indicator.
To activate the cruise assist:
(2) Select the “ ” toggle switch,
and then push the “OK” button on the (1) Operate the throttle lever until the de-
touchpad control. sired engine speed is reached.
(3) Enter the 4-digit PIN code, and (2) When the engine speed reaches the de-
select “ ”. sired cruise assist setting, push the
EJU46390 “CRUISE/NO WAKE” switch. Once the
Cruise assist beeper sounds three times and the
The cruise assist is a function for maintaining cruise assist indicator is displayed, the
a desired engine speed within a fixed range cruise assist is activated.
while operating the watercraft. Once the
cruise assist is activated, the set engine
speed can be increased or decreased. How-
ever, the adjustment is limited to a maximum
of five increments above or below the initial
cruise assist setting.
TIP
The cruise assist can only be set between en-
gine speeds of approximately 4000 r/min and 1
approximately 7000 r/min.
1 “CRUISE/NO WAKE” switch
Activating and deactivating the cruise as- (3) When the cruise assist is activated, slow-
sist
Activation of the cruise assist can be con- ly squeeze the throttle lever to keep it
squeezed further than the position at
firmed by the cruise assist indicator on the
which the cruise assist was set.
multifunction information center.
TIP
Check the multifunction information center to
make sure that the cruise assist is activated
before squeezing the throttle lever to the full
throttle position. If the cruise assist is not ac-

42