Page 51 - LIT-18626-15-27

UF5S10E0.book Page 41 Monday, September 23, 2024 2:13 PM

Watercraft operation

the engine speed can be adjusted to one en-
gine speed each above and below the initial
engine speed.
This function can be used only when the wa-
tercraft is in neutral, or when the watercraft is
shifted into forward and the engine is operat-
ing at idling speed.
TIP
If the no-wake mode is activated when the 1
watercraft is in neutral, the watercraft will au-
1 “CRUISE/NO WAKE” switch
tomatically shift into forward and the water-
craft will start moving at a low speed. (3) Push the upper side or the lower side of
the “SPEED ADJUST” switch to adjust
Activating and deactivating the no-wake the engine speed to three settings: “No
mode
Wake –1”, “No Wake” (standard setting),
The activation of the no-wake mode can be
and “No Wake +1”.
confirmed by the no-wake mode indicator on
the multifunction information center.

RPM x1000
MPH
No Wake +1 1
14.3v
1 “SPEED ADJUST” switch
1 2
1 No-wake mode indicator To deactivate the no-wake mode:
2 No-wake mode level Perform one of the following operations. The
beeper sounds two times and the no-wake
To activate the no-wake mode:
mode indicator disappears when the no-
(1) Shift into neutral, or release the throttle
wake mode is deactivated.
lever and let the engine speed return to
 Push the “CRUISE/NO WAKE” switch.
idle.
 Squeeze the throttle lever.
(2) Push and hold the “CRUISE/NO WAKE”
 Squeeze the RiDE lever.
switch. Once the beeper sounds three
TIP
times and the no-wake mode indicator is
The no-wake mode is also deactivated when
displayed, the no-wake mode is activat-
the engine is stopped.
ed.

41