Page 54 - LIT-18626-15-27

UF5S10E0.book Page 44 Monday, September 23, 2024 2:13 PM

Watercraft operation

tivated, the engine will respond normally to
the throttle operation.
(4) Once the cruise assist is activated, push
the upper side of the “SPEED ADJUST”
RPM x1000
switch to increase the set engine speed
MPH or the lower side of the “SPEED AD-
Cruise Assist +5
JUST” switch to decrease the set engine
14.3v speed. The engine speed can be
1 2 changed in the range of the cruise assist
1 Cruise assist indicator levels –5 to +5.
2 Cruise assist level
To activate the cruise assist:
(1) Operate the throttle lever until the de-
sired engine speed is reached.
(2) When the engine speed reaches the de-
sired cruise assist setting, push the
“CRUISE/NO WAKE” switch. Once the
beeper sounds three times and the 1
cruise assist indicator is displayed, the
cruise assist is activated. 1 “SPEED ADJUST” switch
TIP
Because the cruise assist can only be set be-
tween engine speeds of approximately 4000
r/min and approximately 7000 r/min, the
cruise assist level cannot be adjusted to an
engine speed outside of this range.
To deactivate the cruise assist:
1 Relax your grip on the throttle lever past the
position at which the cruise assist was set.
1 “CRUISE/NO WAKE” switch
The beeper sounds two times and the cruise
(3) When the cruise assist is activated, slow-
assist indicator disappears when the cruise
ly squeeze the throttle lever to keep it
assist is deactivated.
squeezed further than the position at
which the cruise assist was set.
TIP
Check the multifunction information center to
make sure that the cruise assist is activated
before squeezing the throttle lever to the full
throttle position. If the cruise assist is not ac-

44