Page 53 - LIT-18626-13-92

UF3X14E0.book Page 44 Monday, July 11, 2022 11:31 AM

Watercraft operation

TIP
The cruise assist can only be set between en-
gine speeds of approximately 3000 r/min and
approximately 7000 r/min.

Activating and deactivating the cruise as-
sist
Activation of the cruise assist can be con-
firmed by the cruise assist indicator on the
1
multifunction information center.
1 “CRUISE/NO WAKE” switch
(3) When the cruise assist is activated, slow-
ly squeeze the throttle lever to keep it
squeezed further than the position at
which the cruise assist was set.
MPH
RPM
x1000 TIP
Cruise Assist +4
Check the multifunction information center to
10 :00 AM
12.7 V make sure that the cruise assist is activated
1 2 before squeezing the throttle lever to the full
1 Cruise assist indicator throttle position. If the cruise assist is not ac-
2 Cruise assist level tivated, the engine will respond normally to
To activate the cruise assist: the throttle operation.
(1) Operate the throttle lever until the de- (4) Once the cruise assist is activated, push
sired engine speed is reached. the upper side of the “SPEED ADJUST”
(2) When the engine speed reaches the de- switch to increase the set engine speed
sired cruise assist setting, push the or the lower side of the “SPEED AD-
“CRUISE/NO WAKE” switch. Once the JUST” switch to decrease the set engine
beeper sounds three times and the speed. The engine speed can be
cruise assist indicator is displayed, the changed in the range of the cruise assist
cruise assist is activated. levels –5 to +5.

44